buildtak flexplate system

Buildtak FlexPlate System | 3D Printer Upgrade You Didn’t Know You Needed

I have had my eyes on the Buildtak FlexPlate System for quite a while but never pulled the trigger. Well finally I decided to give it a go and wow is it a game changer. Don’t get me wrong you can use a spatula to remove your prints and that works I have used it for years. However, for flat prints it can be a complete pain in the rear to get prints off of the bed. With the FlexPlate from Buildtak the whole bed is stuck on by magnets so after a print you remove the bed flex the plate until your print pops off and you are ready to print again. I plan on picking these up for most of the printers that I run often. I put together a video showing how easy it is to install and use:

About: Daniel


Leave a Reply

Your email address will not be published. Required fields are marked *